Symbol LS 1006 Product Reference Manual page 14

LS 1006 Scanner Product Reference Guide
2. Attach the modular connector of the Y-cable to the scanner port on the scanner.
3. Connect the round male DIN host connector of the Y-cable to the keyboard port on
the host device.
4. Connect the round female DIN keyboard connector of the Y-cable to the keyboard.
5. If needed, attach the optional power supply to the conenctor in the middle of the Y-
cable.
6. Make sure all connections are secure.
7. Switch on your host system. You are now ready to read bar codes.
During scanning, PC-compatible host terminals should be in CAPS LOCK OFF mode.
Figure 1-1. LS 1006 Keyboard Wedge Configuration with Y -Cable
1-4