Symbol LS 1006 Product Reference Manual page 27

* active low
Standard Use
Beeper Sequence
1 Beep - short high tone
4 Beeps - long low tone
4 Beeps - short high tone
3 Beeps - short high tone
Parameter Menu Scanning
1 Beep - short high tone
1 Beep - warble sound
2 Beeps - long low tone
Table 3-2. Pinouts (Continued)
Pin LS 1006
N.C.
6
DTR
7
8 TXD*
9 CTS
Clock
10
Table 3-3. Beeper Indications
A bar code symbol was decoded (if decode beeper is
enabled).
A transmission error has been detected in a scanned
symbol. The last data scanned was lost. Scan the last
data again.
Low power indication; no further scanning is possible.
Change or recharge battery.
Power-up (continuous power mode only)
Appropriate menu within the scanning sequence has
been read
Parameter value entered successfully
Parameter not entered, or incorrect sequence performed.
Scan CANCEL and restart the scanning sequence.
Maintenance and Specifications
Function
Non-Connected (for
RS-232C)
Data Terminal Ready
(for RS-232C)
Transmit Data
Output (for RS-
232C)
Clear to Send (for RS-
232C)
Clock Line (for
Synapse)
Indication
3-7