Introduction - Symbol LS 1006 Product Reference Manual

Introduction

This chapter provides information on how to program the LS 1006 scanner. Before
programming the scanner, follow the instructions in Set-Up on page 1-3.
The Table 4-1 illustrates the default values with which the scanner is shipped. If the default
values suit your requirements, scan the SET ALL DEFAULTS barcode. This will set the
scanner to the default parameters. Changing the scanner's programmable parameters is
accomplished by scanning the bar codes provided in this section.
The following table lists the defaults for all parameters. If you wish to change any option,
scan the appropriate bar code(s).
Set Default Parameter
Terminal Selection
Country Selection
Power On Beep
Beep after Decode
Beeper Tone
Beeper Volume
Decode Attempt Time
Transmit "No Decode" message
Decode Redundancy
Code Types
UPC/EAN
Enable/Disable UPC/EAN
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Decode UPC Only
Table 4-1. Default Table
Parameter
Programming the LS 1006
Default
All Defaults
IBM PC/AT
North America
Enable
Enable
Middle
High Level
1 second
No Message
Disable
All
Enable
Enable
Enable
Disable
Page Number
4-8
4-8
4-9
4-10
4-10
4-11
4-11
4-12
4-13
4-13
4-14
4-15
4-15
4-15
4-15
4-3