Display Installation - Simrad NSS evo2 series Installation Manual

Display installation

Bracket mounting - 7", 9" and 12" models
Place the bracket in the desired mounting location, and use a pencil or permanent marker to
mark drilling locations.
¼ Note:
ensure that the chosen location has enough height to accomodate the display fitted in
the bracket, and allows tilting of the display. Also adequate space is required on both sides to
allow tightening and loosening of the knobs.
Use fasteners suited to the mounting surface material. If the material is too thin for self
tappers, reinforce it, or mount bracket with machine screws and large washers. Use only
304 or 316 stainless steel fasteners. Mark the screw locations using bracket as template, and
drill pilot holes. If mounting surface is steel, or carbon fibre, some form of isolating gasket
or sealant is recommended between the surface and the bracket. Also apply anti-seize
compound to the fasteners.
Screw down the bracket.
Mount the display to the bracket using the knobs. Hand tighten only. The ratchet teeth in
the bracket and display case ensure a positive grip and prevent the unit changing from the
desired angle.
¼ Note:
If mounting location may be subject to salt water spray, consider using an anti-seize
compound on the thread of the knobs, to prevent them from binding with the unit.
Hardware installation | NSS evo2 Installation Manual
| 5