Simrad NSS evo2 series Installation Manual page 36

Hide thumbs Also See for NSS evo2 series:
Table of Contents

Advertisement

30 |
1
1
Counter rudder too low; overshoot response
2
Counter rudder too high; sluggish and creeping response
3
Correct setting of counter rudder; ideal response
Auto trim
This parameter defines how fast the autopilot shall correspond after having registered a
heading error.
The standard value is 40 seconds which should work well on most boats. Rule of thumb: Set
to same value (seconds) as the boat's length in feet. On boats operating on VRF the value
should be set to 20 seconds.
Rate limit
Sets the maximum allowed rate of turn.
The value should be kept at 6.0°/second unless there is a need for more rapid response in
turns.
Minimum rudder
This parameter filters small rudder commands to prevent high rudder activity.
Some boats may have a tendency to not respond to small rudder commands around the
"course keeping" position because of a small rudder, a rudder deadband, whirls/disturbance of
the water-stream passing the rudder or it is a single nozzle water jet boat.
By increasing the Minimum rudder parameter you may improve the course keeping
performance on some boats. This will however increase the rudder activity.
Minimum wind angle to port and starboard
These parameters should be set identical to the minimum apparent wind angle that will keep
the sails from stalling and maintain boat speed. The parameters will vary from boat to boat.
The settings are used for the tack-prevent function. They also apply when the autopilot is
operating in WindNAV mode.
You can select different minimum wind angles for port and starboard. The difference between
port and starboard will be taken into account when calculating the Distance To Turn (DTT).
Navigation change limit
This parameter defines the maximum course change that the autopilot is allowed to make
when the NSS evo2 is following a route (NAV steering).
If the required course change to the next waypoint in a route is more than the set limit, you
are prompted and must acknowledge the course change before the autopilot will turn the
vessel.
Software setup |
NSS evo2 Installation Manual
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents