Simrad NSS evo2 series Installation Manual page 38

32 |
3.
Select the 'Calibrate' option.
4.
Set the 'actual amount used' based on amount of fuel added to tank.
5.
Select OK to save settings. The 'Fuel K-Value' should now show a new value.
¼ Note:
To calibrate multiple engines repeat the steps above, one engine at a time. Alterna-
tively, run all engine simultaneously, and divide the 'Actual amount used' by the number of
engines. This assumes reasonably even fuel consumption on all engines.
¼ Note:
Calibrate option is only available when 'Set to full' is selected, and a Fuel Flow is con-
nected and set up as a source.
¼ Note:
A maximum of 8 engines is supported using Fuel Flow sensors.
Fuel Level
With the use of a Navico Fluid Level device connected to a suitable tank level sensor, it is
possible to measure the amount of fuel remaining in any equiped tank. The number of tanks
must be set in 'Vessel Configuration' to allow discrete tank assignment of the Fluid Level
devices. Under 'Device list' on the Network page, view the 'Device Configuration' page for each
sensor, and set Tank location, Fluid type, and Tank size.
Refer to the Operator manual on setting up the Instrument bar or a gauge on the Instruments
page using the Fluid Level device data.
¼ Note:
A maximum of 5 tanks is supported using Fluid Level devices.
¼ Note:
Tank data that is output by a compatible engine gateway can also be displayed, how-
ever tank configuration for such a data source is not possible via the NSS evo2 displays.
Software setup | NSS evo2 Installation Manual