Turning On Power; Wireless Receiver Functions - Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual

6.2. Turning on Power

When the wireless receiver is powered by the
indoor unit after installation, the
and the indicator blink in yellow green and
in orange for 3 seconds respectively.

6.3. Wireless Receiver Functions

(1) Normal mode
The mode is intended to allow the paired
wireless remote controllers and the connected
indoor unit to communicate. When the wire-
less receiver is paired with a wireless remote
controller, the
green. When the wireless receiver is commu-
nicating with a wireless remote controller, the
LED blinks in yellow green.
(2) Pairing mode
Hold down the
mode.
Pairing requires operation on the wireless remote controller as well, so operate the wireless re-
mote controller near the wireless receiver.
*For pairing details, refer to "5.2 Pairing" in this manual.
When the wireless remote controllers are not paired, transmission is not available.
Before using an un-paired wireless remote controller, be sure to have it go through a
pairing process.
(3) Resetting pairing information
When pairing information has been cleared, ALL the wireless remote controllers need go
through a pairing process again. Therefore, implement this operation with great care.
Holding down the
while in the pairing mode clears all the pairing
information.
17
indicator
LED comes on in yellow
button on the wireless receiver for 3 seconds or more to enter the pairing
button for 5 seconds
Power ON
Not paired
Paired
Transmitting