Pairing - Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual

5.2. Pairing (Mode No. : 1)
The mode is intended to pair the wireless remote
controller with the wireless receiver to enable
wireless communication. Pairing requires opera-
tion on the wireless receiver as well, so operate
the wireless remote controller near the wireless
receiver.
■ Pairing method
Hold down the
ceiver for 3 seconds or more to enter the pair-
ing mode.
The LED will blink orange.
The wireless receiver, once into the pairing
mode, keeps the mode active for 5 minutes
unless the mode is cancelled by re-pressing
the button.
The wireless receiver goes through a pairing process only while the ATW system is
off. When the system is ON, be sure to turn it off before beginning the pairing proc-
ess.
Press the or
address, and press the
setting .
The initial address is "
available address ranges from 1 to 8.
After saving the setting, the wireless remote
controller starts communication with the wire-
less receiver.
When pairing multiple wireless remote controllers, be sure to set different address for
each individual controller.
button on the wireless re-
button to select the pairing
button to save the
" (no setting), and the
12