Table of Contents
Advertisement
cLeANING and MAINteNANce
Make sure the gas valve knob is in the "OFF" position. Wait
at least five (5) minutes before start-ing maintenance.
VeNtING SySteM
A qualified agency should examine the venting system
annually.
cLeANING GLASS
Clean the ceramic glass periodically. Condensation will
sometimes form on the glass during a cold startup. This is
normal for all gas fireplaces and inserts. This condensation
often attracts dust and lint to the surface of the glass. The
initial paint curing of the appliance can also leave a slight
film on the glass. This is a temporary problem.
Figure 44 -
Typical Burner Flame
83D4009
LG835
VLI31 log flame
You should clean the glass after the first two weeks of use.
After that, you should clean the glass no more than two or
three times a season. Use a mild glass cleaner to clean
the door. Do not use abrasive cleaners. They will damage
the glass surface.
PILOt AND BuRNeR FLAMeS
Visually check pilot and burner flames periodically. Refer
to Figure 44 for typical burner flame. Refer to Figure 45
for typical pilot flame.
LG836
Figure 45 -
Typical Pilot Flame
VLI31 Fireplace Insert
Sensor
Thermopile
FP453
FP2453
hooded pilot flames
37
Advertisement
Table of Contents
