Table of Contents
Advertisement
Quick Links
Vented Gas Log Set
Model: VDY24/18
Installation and
Operating Instructions
WARNINGS
If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or loss of
life.
–
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
–
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
–
Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
4949
VDY log cover
This gas log set is to be installed only in a
solid-fuel burning fireplace with a working flue
constructed of noncombustible material.
Approved to ANSI Z21.60 / CSA 2.26
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future refer-
ence.
20304949 1/13 Rev. 2
Advertisement
Table of Contents
Related Manuals for Vermont Castings DUZY VDY24/18
Summary of Contents for Vermont Castings DUZY VDY24/18
-
Page 1: Operating Instructions
Vented Gas Log Set Model: VDY24/18 Installation and Operating Instructions WARNINGS 4949 If the information in this manual is not followed VDY log cover exactly, a fire or explosion may result causing property damage, personal injury or loss of life. –... -
Page 2: Table Of Contents
CONTENTS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire Thank you and congratulations on your purchase of an Vermont Castings Group Log Set. PLEASE READ THE INSTALLATION AND OPERATION INSTRUCTIONS BEFORE USING THE APPLIANCE! IMPORTANT: Read all instructions and warnings carefully before starting installation. -
Page 3: Important Safety Information
3. Installation and repair should be done by a qualified 14. The gas log set and its individual shutoff valve must be service person. Vermont Castings Group Vented Gas disconnected from the gas supply piping system during Logs must be installed only in a solid-fuel (wood) burn-... -
Page 4: Getting Started
FEATURES & SPECIFICATIONS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire GAS PRESSURES MAkE SURE YOU HAVE RECEIVED ALL PARTS: Natural *Propane (LP) Check your packing list to verify that all listed parts have Inlet Minimum 6.0”... -
Page 5: Minimum Hearth Dimensions
PRODUCT SPECIFICATIONS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire INSTALL AND OPERATE THE APPLIANCE MINIMUM HEARTH DIMENSIONS AS DIRECTED IN THIS MANUAL DAMPER STOP INSTALLATION A damper stop is provided with the unit. The damper stop must be installed as shown in Figure 2 to prevent full clo- sure of the fireplace damper blade and provide a minimum flue opening, per table below. -
Page 6: Placement In A Fireplace With A Restrictive Barrier
PLACEMENT WITH A RESTRICTIVE BARRIER "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire IMPORTANT INFORMATION FOR THE IN- The log set STALLATION OF THIS GAS LOG SET should be placed against The following are guidelines for placing a gas log set or as near as Glass door possible to the... -
Page 7: Installation
INSTALLATION "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire GAS LINE CONNECTION PLACE AND SECURE APPLIANCE NOTICE: A qualified gas appliance installer must connect You must secure the gas log heater to the the heater to the gas supply. Consult all local codes. fireplace floor. -
Page 8: Electrical Wiring
GAS LINE CONNECTION / ELECTRICAL WIRING "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire The heater gas inlet connection is 3/8" NPT at the regula- Label all wires prior to disconnection when tor, inlet on the right side facing the gas log. If a left side servicing controls. -
Page 9: Optional Remote Receiver
ELECTRICAL WIRING "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire THTP Millivolt Valve Pilot Figure 7 - Switch Optional Wall Switch Wiring Diagram or Remote Receiver FP2857 FP2857 REMOTE RECEIVER INSTALLATION millivolt wiring DO NOT PLACE THE REMOTE IN THE •... -
Page 10: Log Placement
LOG PLACEMENT "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire LOG PLACEMENT IMPORTANT: Remove logs, handling carefully by holding gently at each end. Gloves are recommended to prevent skin irritation from ceramic fibers. If skin becomes irritated, wash gently with soap and water. - Page 11 LOG PLACEMENT "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire Middle Right Middle Left Log #5 Log #4 4. Place one end of middle left log (#4) on bottom left log. Rest other end of middle left log (#4) behind middle right log.
-
Page 12: Glowing Ember Placement
At this point the damper stop should be adjusted so that the damper opening is increased. If the problem re- Although Vermont Castings Group goes to great mains after the open area of the damper is increased, then lengths to design vented gas log sets that minimize the fireplace system should be professionally inspected to sooting, all vented log sets will soot over time. -
Page 13: Flame Appearance
FLAME APPEARANCE "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire CHECkING BURNER FLAMES In normal operation at full rate after approximately 15 minutes, the following flame appearance should be ob- Rear flame should served. be yellow and extend vertically. -
Page 14: Operating Instructions
OPERATING INSTRUCTIONS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance is equipped with an ignition device which automatically lights the pilot. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. -
Page 15: Millivolt Control Lighting Instructions
OPERATING INSTRUCTIONS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire MILLIVOLT CONTROL LIGHTING INSTRUCTIONS 1. STOP! Read the safety information label. 2. Make sure the manual shutoff valve is fully open. 3. This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo ignitor does not light the pilot, see instructions for Match Lighting below. -
Page 16: Cleaning And Servicing
CLEANING AND SERVICING "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire Turn off gas logs and allow to cool before cleaning. Disconnect electrical power if applicable before cleaning or servicing. Remove logs, handling carefully by holding gently at each ANNUAL CLEANING/INSPECTION - SEE PARTS end. -
Page 17: Troubleshooting
TROUBLESHOOTING "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire Turn off appliance and allow to cool before NOTE: All troubleshooting items are listed in order of operation. cleaning. Only a qualified service person should service and repair the heater. - Page 18 TROUBLESHOOTING "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire Problem Possible Cause Solution 1. Press in control knob fully. Pilot lights, but flame goes 1. Control knob not fully pressed in. out when control knob is 2.
-
Page 19: Replacement Parts
REPLACEMENT PARTS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire 24/18 MODELS Ref. Description VDY24/18NVP VDY24/18PVP 4949 Main Injector 32D0100 32D0507 VDY parts Control Knob 18D0603 18D0603 Millivolt Control Valve w/Pilot 27D8006 27D8005 Pilot 27D8974 27D8973 Thermocouple/Thermopile... - Page 20 REPLACEMENT PARTS "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire DUZY (V) LOG SERIES Ref. Description Qty. VDY24/18D5 Back Log 32D3121 Bottom Right Log 32D3122 LG1015 Bottom Left Log 32D3123 VDY2418D5 logs Middle Left Log 32D3124 Middle Right Log 32D3125...
- Page 21 "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire 20304949...
-
Page 22: Massachusetts Requirements
Massachusetts Residents Only — Please read and follow these special requirements "Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire 2. Approved Carbon Monoxide Detectors. Each carbon NOTE REGARDING VENTED PRODUCTS monoxide detector as required in accordance with the above This product must be installed by a licensed plumber or gas fitter provisions shall comply with NFPA 720 and be ANSI/UL 2034 when installed within the Commonwealth of Massachusetts. -
Page 23: Warranty
After installation, if any of the components manufactured by Vermont Castings Group in the appliance are found to be defective in materials or workmanship, Vermont Castings Group will, at its option, replace or repair the defective components at no charge to the original owner. - Page 24 Technical Service Costco (Bilingual) 1-800-463-3783 Vermont Castings Group 1-866-500-5670 Vermont Castings Group 149 Cleveland Drive • Paris, Kentucky 40361 www.vermontcastingsgroup.com...
Need help?
Do you have a question about the DUZY VDY24/18 and is the answer not in the manual?
Questions and answers