OBH Nordica Pro Mix 1000W Instructions Of Use page 36

Functions of the blender:
Ice crush
Smoothie
Interval
Min- max speed The blender has a stepless speed setting. Start at a low speed
We recommend that you try your way to find the speed that is best for the
ingredients to be mixed. Always keep an eye on the mixing and switch off the
appliance, when the wanted result has been obtained. Always unplug after use.
Never use the blender for more than 3 minutes at a time. Let the blender rest
for 1 minute before you activate it again (in order to avoid overheating).
Never remove the glass jug while the motor is on.
nOtE! Do not activate the blender with only dry ingredients (e.g. nuts) in the
jug, as this may damage the blender. Always add a small amount of liquid
before you activate the appliance.
Mixing of hot liquid
The glass jug can withstand hot ingredients and
hot liquids/ soups. Pouring hot liquid into a closed
container (like e.g. a blender jug with lid) will
automatically create high pressure. Consequently,
there is a rick that the lid goes off during use and that
hot liquid may squirt. In order to avoid this, proceed as
follows:
36
Put max 200 g of ice in the jug. The blender works in pulse
intervals for appr. 1 minute unless it is switched off manually
by means of the on/off button or by pressing the ice crush
button.
The blender works at various speeds alternating for appr. 1
minute unless it is switched off manually by means of the on/
off button or by pressing the smoothie button.
The blender works at various speeds alternating for 45
seconds unless it is switched off manually by means of the
on/off button or by pressing the interval button again.
and increase if needed. Note that ice crush, smoothie and
the interval functions cannot be activated, when you use the
stepless speed function. Turn the function selector to the
wanted speed and start the mixing by means of the on/off
button. Switch off the blender by pressing the on/off button
in the middle of the function button and turn the function
button back to 0.