Bulb Installation - Intertek RSS52 Installation Manual

BULB INSTALLATION

Installing bulbs in the motor housing, locate
the four access plates on the motor housing
top. Remove two screws per access plate to
reach each socket, use phillips screwdriver.
Install each candelabra base Type C, 7W
bulbs (Not Included). Reattach the access
plates.
CAUTION - Refer to the Maximum Wattage Caution
Label located near the lamp holder for
recommended maximum wattage-do not
exceed recommended wattage.
WARNING - Do not attempt to replace the bulbs
while the line breaker is in ON position.
BULB INFO: E12, Type C, 7W x 4 (Not Included)
WARNING: DO NOT EXCEED INDICATED BULB WATTAGE
NOTE: Your fan is equipped with a wattage limiter, if you exceed the indicated wattage your ceiling fan will not function.
6. Flush Mount Assembly
1. Remove round rubber ring from the canopy
2. Thread electrical wire through the canopy.
3. Remove every other screw on the motor housing
total of 3 screws.
4. Attach the canopy to the motor housing with the 3
screws.
5. Continue to step 8 for wiring without the remote
control. Then install the assembled motor housing
along with the canopy to the hanging bracket. Continue
to step 10.
6. If you are installing the remote control (sold
separately), read Remote
Instructions, then install the assembled motor housing
along with the canopy to the hanging bracket, then continue to step 10.
MODEL NO.:RSS52
Installation
Page
6