Advertisement
Important:
READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION
DO NOT install this product in areas where the
following may be present or occur:
• Excessive oil or a grease laden atmosphere.
• Corrosive or flammable gases, liquids or
vapours.
• Ambient temperatures are outside 5-50°C.
• Possible obstructions which would hinder the
access or removal of the Fan.
SAFETY AND GUIDANCE NOTES
A. All wiring to be in accordance with the current
I.E.E. Regulations, or the appropriate standards
of your country and MUST be installed by a
suitably qualified person.
B. The Fan should be provided with a local isola-
tor switch capable of disconnecting all poles,
having a contact separation of at least 3mm.
C. Ensure that the mains supply (Voltage,
Frequency, and Phase) complies with the rating
label.
D. The Fan should only be used in conjunction
with the appropriate Vent-Axia products.
E. The fan should only be used in conjunction with
fixed wiring.
F. When the Fan is used to remove air from a
2
room containing a fuel-burning appliance,
ensure that the air replacement is adequate for
both the fan and the fuel-burning appliance.
G. The Fan should not be used where it is liable to
be subject to direct water spray for prolonged
periods of time.
H. Where ducted Fans are used to handle
moisture-laden air, a condensation trap should
be fitted. Horizontal ducts should be arranged
to slope slightly downwards away from the Fan.
I. This appliance is not intended for use by young
children or infirm persons without supervision.
J. Young children should be supervised to ensure
that they do not play with the appliance.
K. The exterior grille should be at least 2.3m
above the ground to prevent people from being
able to access moving parts. If the external
grille is positioned between 0-2.3m from the
ground, please use the Vent-Axia wall kit to
ensure people cannot access the fans impeller
from the outside.
Operating and installation instructions
Installation
Installation Preparation
• Loosen the motor unit by grasping it as shown in
Figure (A), prise off the motor unit by leavera-
ging against the cap with your knuckles. Ensure
that you have the motor unit in a secure grip so
you do not drop it when it loosens.
• Then loosen the wall frame by using a screw–
driver pressing the lock button as shown in
Figure (B) then remove the cover from the wall
frame according to figure (C).
A.
B.
Operating and installation instructions
Installer information
C
New Installations
New installations require holes using a Ø110 mm
hole saw (Figure D).
Ø 110 mm
D.
3
Advertisement
