Canopy Assembly; Blade Assembly - Intertek RSS52 Installation Manual

MODEL NO.:RSS52

. Canopy Assembly.

9
If necessary, partially loosen the 2 screws on the
bottom of the hanging bracket. Lift canopy to
hanging bracket, aligning rounded part of holes
in canopy with loosened screws in hanging
bracket, and push up. Twist canopy to lock.
Securely tighten 2 screws.

10. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first, and then tighten screws
securely with a philips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers
from fan motor and set aside. Then, if applicable,
remove motor shipping pads and discard. Align
blade arm holes with motor screw holes and
attach blade arm with lock washers and blade
arm screws. Before securing screws completely,
Repeat procedure with remaining blade arms.
Secure all screws.
*REMOVE SHIPPING MOTOR PADS AND DISCARD*
Page
9