Fan Assembly - Intertek RSS52 Installation Manual

MODEL NO.:RSS52
.
7 Fan Assembly with Down Rod
- Choose the 4" or 21" Down Rod -
Remove pin and clip from down rod (if you have
not already done so). Slide down rod through
canopy, and down rod cover.
Thread electrical wires through downrod and
Pull extra wire slack from the upper end of the
downrod.
Tip: Apply small piece of electrical tape to the
ends of the electrical wires to keep them
together when threading them through the
down rod.
Loosen yoke set screws and nuts. Place down rod
into the motor housing yoke and re-insert pin
and clip that were previously removed. Tighten
yoke set screws and nuts securely.
["Fan Assembly continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense, and caution are necessary
factors in the installation and operation of this fan.
Page
7