Maintenance - Intertek RSS52 Installation Manual

5. If the above does not eliminate the wobble, clip a balancing kit on any one of
blade about the middle of blade edge. Let fan run. If it is still wobbling, stop the
fan, and change the location. Repeating this procedure on the remaining blades
until the wobble is removed.
6. You can also look up at the fan from below, make sure that none of the blade
holders are bent so that a blade is out of position. Correction may be made by
GENTLY bending the blade holder back into position.
7. Blade tracking may be checked simply by use of a household yardstick as
shown in below Figure. Place the yardstick vertically against the ceiling and even
with the outside leading edge of a blade. Note the distance of the edge of a
blade same as others. Tum the blade slowly by hand to check the remaining
blades. If a blade is in an alignment, the blade holder may be gently bent up or
down to be in line with the other blades.
1. The fan natural movements may cause some connections to work loose. A
clicking or rattling noise is a certain sign of loosening screws. Check the support
connections, brackets and blade attachment twice a year, and tighten all screws
as necessary. Make sure all screws attaching the glass screws are tightened.
2. Clean your fan periodically. Use only a damp cloth, never use solvents, and dust
with a soft cloth or brush. Metal finishes are finished with a lacquer to prevent tarnishing.
3. You will never need to oil your fan, its permanently sealed bearing will prevent
silent, trouble free operation for many years.
4. Make sure the power is turned off at the main fuse or circuit panel before you
attempt any repairs.
MODEL NO.:RSS52

MAINTENANCE

Page
12