Light Kit Assembly; Testing Your Fan - Intertek RSS52 Installation Manual

MODEL NO.:RSS52

11. Light Kit Assembly.

Remove 3 screws from light kit fitter.
Plug the connector from light kit fitter
to the connector from switch housing.
Please note the correct wiring is
white to white
blue to black
Gently push connector into switch housing and align
holes in light kit fitter with holes in switch housing.
Secure light kit fitter to fan with the 3 screws that
were previously removed.
Attach the glass shade to the light kit fitter using the
finial you will find installed on the light kit pipe. Insert pull
chains through the holes on shade, and then attach the pull
chain FOB. Do not over tighten the finial.
Important: When replacing bulb(s), please allow
bulb(s) and glass shade(s) to cool down before
touching them.
Install: E12, Type B, 40W x 2 (Not Included)
WARNING: DO NOT EXCEED INDICATED BULB WATTAGE
NOTE: Your fan is equipped with a wattage limiter, if you exceed the indicated wattage your ceiling fan will not
function.

12. Testing Your Fan.

It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test fan speeds with pull chain and the reverse switch.
Start at the OFF position (no blade movement).
First pull will set the fan to HI.
Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Next pull will again set the
fan to OFF setting.
Test lights with pull chain in the middle. Start with all of the lights OFF.
The first pull will turn on only the UPPER lights in the lighting housing.
The second pull will turn on only the LOWER lights in the light kit.
The third pull will turn on ALL of the lights (upper and lower)
and the fourth pull will turn all of the lights OFF again.
If fan and /or lights do not function, please
refer to "Trouble shooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off when moving the reverse switch.
Set reverse switch to recirculate air, depending on the season.
Pull chain extensions supplied, or a custom pull chain extension
(sold separately) can be attached to fan. Insert pull chain through
hole on shade then attach pull chain to pull chain FOB.
Page
10