Table of Contents
Advertisement
Network settings
Set when networking with a computer.
[Network settings] submenu will be displayed.
Network settings
Network control
Auto display name
Display name
LAN setup
Network status
DIGITAL LINK mode
DIGITAL LINK status
DIGITAL LINK menu
AMX D. D.
Crestron Connected™
Extron XTP
USB memory network settings
Reset
■
[Network control]
Set when controlling with the unit's LAN terminal.
[On]:
Controls via LAN using the LAN terminal of the
Display. The power indicator lights orange when
the power is turned off with the remote control
(standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
●
When using the LAN control function for "Using
Network Function" (see page 81 - 96), set this
function to [On].
■
[Auto display name]
Sets whether to change the display name
automatically.
[On]:
Changes the display name automatically in
accordance with the set point of the display ID.
[Off]:
The display name is not changed automatically.
■
[Display name]
The name of the Display that is shown on the network
can be changed.
Note
●
The name can be changed only when [Auto display
name] is set to [Off].
●
Display ID is not reset to default with [Network
settings] - [Reset].
68
English
Off
On
VF2H-000
Auto
Off
Off
Off
Permit
■
[LAN setup]
Detailed network settings for the LAN established via the
LAN terminal of the Display can be configured.
Select [LAN setup] with
LAN setup
Save
DHCP
IP address
192.168.
Subnet mask
255.255.255.
Gateway
192.168.
Port
MAC address
[DHCP] / [IP address] / [Subnet mask] / [Gateway]
Set [On] / [Off] of [DHCP] with
When [Off] is selected, IP address and other settings
can be set manually.
[DHCP]:
(DHCP client function)
[On]:
Obtains an IP address automatically when a
DHCP server exists in the network the Display is
going to be connected.
[Off]:
When a DHCP server does not exist in the
network the Display is going to be connected,
set [IP address], [Subnet mask] and [Gateway]
manually.
[IP address]:
(IP address display and setting)
Enter an IP address when DHCP server is not used.
[Subnet mask]:
(Subnet mask display and setting)
Enter a Subnet mask when DHCP server is not
used.
[Gateway]:
(Gateway address display and setting)
Enter a gateway address when DHCP server is not
used.
Note
●
When [DHCP] is set to [On], the IP address, etc. will
be displayed in grey.
Entering numbers
IP address
192.168.000.008
1. Select the address and press <ENTER>.
2. Select digits with
3. Change numbers with
4. Press <ENTER>.
You can cancel the change by pressing
<RETURN>.
and press <ENTER>.
Off
0.
8
0
0.
1
1024
--:--:--:--:--:--
.
.
.
Advertisement
Table of Contents
