Table of Contents
Advertisement
Wired Remote Controller Operation Procedure
6）Temp. adjusting
Under the state without time setting, press"▲"and"▼"to
adjust temp..
▲：To rise set temp.；
▼：To reduce set temp.
（ every press of this button, temp. will be risen or
subtracted for 1℃.）
Temp. adjusting ranged from 16 ℃ ～ 30 ℃ under any
running mode.
7）Set of running mode
Every once press of the mode key, the running mode would
be changed according to the following order：
COOL
DRY
Under cooling mode, the display of cooling will on, and the
set temp. should be lower than the present room temp. If the
set temp. is higher than the present room temp., air
conditioner would not enter cooling mode.
Under dehumidify mode, display of dehumidify will on.
Fan will run in low speed in certain temp. range. The
dehumidifying effect of this mode is better than that of
cooling mode, and saves more energy.
Under heating mode, the display of heating will on. The set
temperature should be higher than that of present room; if
the set temp. was lower than that of present room, heating
mode would not be operated.
Under fan mode, the display of fan will on.
8）Malfunction display
When malfunction happened in running, malfunction code will
be shown in environmental temp. display zone. Fig.9 indicates
that the compressor is operating high pressure protect.
When malfunction happened, except fan mode will still work in
normal, outdoor unit and fan will close under mode of cooling,
dehumidify and heating, but LCD display will not be affected.
（Fig.7）
（Fig.8）
FAN
HEAT
（fig.9）
18
MODE
FAN
SWING
TIMER
ON/OFF
Fig7
MODE
FAN
SWING
TIMER
ON/OFF
Fig8
MODE
FAN
SWING
TIMER
ON/OFF
Fig9
Advertisement
Table of Contents
