Table of Contents
Advertisement
Wired Remote Controller Operation Procedure
（Fig.3， the following sketch is displayed according
2） Timer setting
to the functions of wired remote controller）
Press TIMER under off state can set On Time; press TIMER
under on state can set Off Time.
Under the circumstance that without setting time ( there isn't
information in the Timer Time Display Zone), press TIMER, then
the LCD will display the pattern of "
" "and"hours"will keep blinking for 0.5s, press adjusting
button"▲"or"▼"can adjust set time. After adjusting set time by
button "▲"or"▼", repress TIMER once, the pattern" "and
"hours" will no longer blinking, which indicates that TIMER
had been set.
Press TIMER once after electrify, "
repress TIMER once again, then the Timer pattern no loner displayed on LCD, which indicated that the TIMER
setting had been cancelled.
Under the circumstance of TIMER time had been set （ i.e. the state that " "and"hours"don't blink）, repress
TIMER, then the "
will be cancelled after electrify), and both " "and "hours"are blinking, at this time, adjust "▲"or"▼"to reset
timer, or repress TIMER to confirm timer function.
The timer of turning on/off ranged from 0.5-24 hours. Every single press of"▲"or"▼", the set time will be
added or subtracted 0.5 hour. Press"▲"or"▼"serially the set time will add or subtract 0.5 hour
automatically for every 0.5s. The adjusting range of"▲"and"▼"are from 0 to 24, and the mode is
recycling mode.
Button"▲"：
0.0
Button"▼"：
0.0
Note：The above displayed is the relative displaying zone.
xx.x Hours", and the
0.0 hour" is displayed and both of the two patterns are blinking on LCD,
xx.x hours" will be redisplayed on LCD (note： "xx.x" indicates the set time of last time, and
0.5
1.0
0.5
1.0
· · · · · ·
23.5
· · · · · ·
23.5
16
Fig3
24.0
24.0
MODE
FAN
SWING
TIMER
ON/OFF
Advertisement
Table of Contents
