Toyotomi TGS-28FWCA Owner's Manual page 16

Install the cassette type indoor unit
● Install the panel
1. Set the panel to the indoor unit body by matching the position of the swing flap motor of the panel to the piping
position of the panel to the piping position of the indoor unit as shown by fig.4.
2. Install the panel
① Install the panel on the indoor unit temporarily. When install, hang the latch on the hook that is located on the
opposite side of the swing flap on the panel of the indoor unit. (2 positions)
② Hang the remaining 2 latches to the hooks on the sides of the indoor unit.(Be careful not to let the swing motor
lead wire get caught in the sealing material.)
③ Screw the 4 hexagon head screws under the latches in about 15mm. (The panel would rise)
④ Adjust the panel by turning it toward the direction pointed by the arrow as shown in fig.4, so that the adjust
board connect the ceiling well.
⑤ Tighten the screws until the thickness of the sealing material between panel and indoor unit reduced to 5-8mm.
Swing flap motor
Piping position
②
③
④
Indoor unit
Ceiling
Air outlet vent
Fig 4
①
Latch
Sealing material
5mm to 8mm
⑤
Decoration panel
12
Hook
②