Ventilation Requirements - Baumatic BCG520SL Instruction Manual

50 cm twin cavity gas slot-in cooker
Hide thumbs Also See for BCG520SL:
Table of Contents

Advertisement

o The cooker is designed to slot in between 600 mm deep
cabinets, which are spaced approximately 500 mm apart.
o It can also be used as a freestanding unit, with a cabinet to one
side, in a corner setting or with its back to a wall.
o IMPORTANT: It should not be installed at the end of a run of
cabinets, if there is a cabinet at immediate right angles to the
cooker door.
o The wall behind the cooker and 450 mm above and across the
width of the cooker should be of an incombustible material and
preferably an easy clean surface, such as ceramic tiles.
o Any overhanging surface or cooker hood should be at least 700
mm above the highest point on the hob top (including the
burners).
o Baumatic do not recommend that the cooker is positioned below
wall cupboards, as the heat and steam from the appliance and
what is being cooked, may damage the cupboard and its
contents.
o The cooker may be located in a kitchen, or a bedroom, but not in
a room containing a bath or shower. The cooker must not be
installed in a bedroom of less than 20m³ in size.

Ventilation requirements

o The room containing the appliance should have an air supply in
accordance with BS 5440: Part 2.
o For room volumes up to 5m³ an air vent of 100cm² is required.
o If the room has a door that opens directly to the outside, or the
room exceeds 10m³ no air vent is required.
o The cooker is fitted with four feet
that can be adjusted to match
the
height
of
cabinets.
o If the cooker is not level or is
unstable due to an uneven floor
surface, use the adjustable feet
to alter each corner until the
cooker is level.
25
your
kitchen

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bcg520blBcg520ivBcg520r

Table of Contents