Troubleshooting - Sanyo DVR-DX600 Instruction Manual

Troubleshooting

Troubleshooting
Check the following guide for the possible cause of a problem before contacting customer support.
Symptom
No power.
No picture.
No sound.
Playback picture is poor.
DVD Recorder does not
start playback.
Picture from external input
is distorted.
Some channels are skipped
over when using [PR+/–].
Picture or sound of
broadcasting channel is
weak or missing.
Camcorder image not shown.
Camcorder image via A/V
input to DVD Recorder is
not shown on TV screen.
Cause
The power cord is disconnected.
The TV is not set to receive DVD
Recorder signal output.
The video cable is not connected
securely.
The TV power is turned off.
The equipment connected with the
audio cable is not set to receive
DVD Recorder signal output.
The audio cables are not connected
securely.
The power on the equipment
connected with the audio cable is
turned off.
The audio cables are damaged.
The disc is dirty.
No disc is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the
guide.
The disc is dirty.
The Parental Control level is set.
The video signal from the external
component is copy-protected.
The skipped channels were deleted
with the 'Adjust Channels' menu.
Antenna or cables are loose.
Wrong Tuning Band is selected in
the DVD Recorder Setup menu.
Camcorder is off.
DVD Recorder's source is not set to
AV1, AVF, or DV.
Solution
Plug the power cord into the wall outlet
securely.
Select the appropriate video input on the
TV so the picture from the DVD Recorder
appears on the TV screen.
Connect the video cable securely.
Turn on the TV.
Select the correct input mode on the
audio receiver so you can listen to the
sound from the DVD Recorder.
Connect the audio cables securely.
Turn on the equipment connected with
the audio cable.
Replace with new ones.
Clean the disc.
Insert a disc. (Check that the disc
indicator on the front panel display is lit.)
Insert a playable disc. (Check the disc
type, color system, and regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Cancel the Parental Control function or
change the rating level.
You cannot connect via the DVD
Recorder. Connect the component
directly to your TV.
Use the 'Auto Scan' menu to restore
channels. See 'Auto Scan' on page 19.
Tighten connections or replace cable.
Try all 'Tuning Band' options; see page
17 for details.
Turn camcorder on and operate properly.
Use [INPUT] to select AV input channel
(AV1, AVF, or DV).
49