Connections; Connecting Antenna/Cable - Sanyo DVR-DX600 Instruction Manual

Hide thumbs Also See for DVR-DX600:

Table of Contents

Connections

• There are a variety of ways to connect the DVD Recorder to your TV and other equipment. Use only one of the

connections described below. Whichever TV connection you use will work with all input sources.

• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best

connections.

• For better sound reproduction, connect the DVD Recorder's AUDIO OUT jacks to the audio in jacks of your

amplifier, receiver, stereo, or audio/video equipment. See 'Connecting an Amplifier/Receiver' on page 13.

Caution

• Make sure the DVD Recorder is connected directly to the TV, and the TV is set to the correct video input.

• Do not connect the DVD Recorder's AUDIO OUT jack to the phono in jack (record deck) of your audio system.

• Do not connect the DVD Recorder via your VCR. The DVD image could be distorted by the copy protection system.

Disconnect the antenna/cable from the rear of

your TV.

Connect this cable to the jack marked ANT IN

(FROM ANT.) on the rear panel of the DVD

Recorder.

If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your

TV and attach it to the ANT IN (FROM ANT.) jack on the rear panel of the DVD Recorder.

Use the supplied coaxial cable to connect between the DVD Recorder's OUT (TO TV) jack and the antenna input

jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all

cable channels).

Antenna

Flat Wire

(300ohm)

(300 ohm)

300/75 ohm

300/75ohm Adapter

Adaptor

(Not supplied)

Antenna

Cable TV

Wall Jack

Rear of DVD Recorder

Table of Contents