Device Commands - Dataprobe iBootBar iBB-N15 Installation And Operations

Device Commands

Command
get devices / get all / get outlets
get device <#1‐#16/devname>
set device <#1‐#16 > name <name>
get current
get device <#1‐#16/devname> current
get cycle
set cycle <1‐99>
get delay
set delay <1‐99>
get current alarm
get device <#1‐#16/devname> current alarm
set main <a/b> highalarm <nn.n>
set device <#1‐#16/devname> main <a/b>
highalarm <nn.n>
set main <a/b> highalarm <nn.n>
set device <#1‐#16/devname> main <a/b>
lowalarm <nn.n>
Page 18
Description
This command displays a list of connected devices, and their current status.
Get device information. Displays the device name, and all outlet names and current
status
Set the name of the selected iBootBar. 20 characters max.
Gets the measured current of the local iBootBar
Get the measured current of the selected iBootBar
Get or set the cycle time in seconds.
Get or set the delay time in seconds.
High and Low alarms are used to monitor current conditions and send an alert by
email, SNMP and syslog when the high or low thresholds are exceeded.
From 0.0 to 10.0/15.0/20.0 (depending on max current for device) in 0.1 amp
increments. For devices with two Mains, Main A and Main B are set separately, but
displayed together with the get command.
Admin
Fact Default
No
Yes Dataprobe
Yes
No 10
No 1
Yes Highalarm:
10.0 for 10 Amp
Models
15.0 for 15 Amp
Models
20.0 for 20 Amp
Models
Lowalarm:
0.0 Amp
iBootBar V1.5x