Installing An Sodimm - DFI TPC121 User Manual

Installing an SODIMM

1. Locate the DIMM socket on the system board.
2. Push the ejector tabs which are at the ends of the socket at the side.
Ejector tab
3. Note the key on the socket. The key ensures the module can be plugged into the socket in only
one direction.
Chapter 3 Installing Devices
Chapter 3
Chapter 3
SODIMM socket
Ejector tab
19
4. Grasping the module by its edges, position the module above the socket with the notch in the
socket aligned with the key on the module. Apply fi rm even pressure to each end of the module
until it slips down into the socket. The contact fi ngers on the edge of the module will almost
completely disappear inside the socket.
5. Push the module down until the clips at each end of the socket lock into position. You will hear
a distinctive "click", indicating the module is correctly locked into position.
Clip
SODIMM
Clip
www.dfi .com