Connecting Cables To Terminal Blocks - DFI TPC121 User Manual

Connecting Cables to Terminal Blocks

1. Insert the cable end of the power adaptor to the terminal block. To fi rmly fi x the cable into the
terminal block, use a screwdriver to clamp down the wires to the screw that is in the terminal
block.
Terminal block
Wire
Power adapter cable
Chapter 3 Installing Devices
Chapter 3
Chapter 3
2. Plug the terminal block into the DC-in connector and then tighten the screws to secure the
terminal block in place.
DC-in connector
Screws
25
www.dfi .com