Operational Instructions - Stamina DT PRO 35-1485 Owner's Manual

OPERATIONAL INSTRUCTIONS

HEART RATE TRANSMITTER
The Stamina® DT PRO Rower can measure how hard you are exercising by monitoring your heart rate
with the HEART RATE TRANSMITTER(98). Your heart rate reading gives you a snapshot of how hard your
heart is working at that point in your workout by measuring the number of heart beats per minute.
The HEART RATE TRANSMITTER(98) worn around your chest sends your heart rate information to a
receiver inside the COMPUTER(93) so your heart rate is tracked while you exercise. This is the most reliable
way to measure your heart rate to make sure you are exercising within your target heart rate zone so you
get the most out of your workout time.
Using the Heart Rate Transmitter Chest Strap
The HEART RATE TRANSMITTER(98) worn around the chest is powered by a BUTTON BATTERY
(CR2032)(102) located in the center of the strap. Two electrodes on either side of the battery monitor your
heartbeat, and an adjustable ELASTIC STRAP(99) holds the transmitter in place. The receiver built into
the Stamina® DT PRO Rower picks up your heart rate from the HEART RATE TRANSMITTER(98) and
displays it on the monitor during your workout.
To assemble the HEART RATE TRANSMITTER(98),
insert the BUTTON BATTERY(CR2032)(102) as shown
in the illustration. Place the BATTERY RUBBER
RING(100) on the edge of the opening and place
the BATTERY COVER(101) over the BUTTON
BATTERY(CR2032)(102). Using a coin or similar object,
press down on the BATTERY COVER(101) and turn
counterclockwise to securely close the cover.
NOTE: 1. Make sure to close the BATTERY COVER
(101) very tightly as illustrated to prevent
sweat and moisture from damaging the
battery.
2. The HEART RATE TRANSMITTER(98) is
latex free and its material is appropriate for
human contact.
Attach the ELASTIC STRAP(99) by inserting the oval-shaped tabs through the openings in the transmitter
and twisting. Adjust the ELASTIC STRAP(99) to fit your chest snugly as shown in the illustration below.
(99) Elastic Strap
Oval-shaped Tab
To ensure a secure connection above, be sure that the front
edge of the oval-shaped tab is completely inside of the oval-
shaped opening on the HEART RATE TRANSMITTER(98).
NOTE: Apply water or conductive gel to moisten the
Hexagonal Rubber Area covering the electrodes. This
rubber area must be wet and in contact with your chest
skin to properly detect your heart rate.
(98) Heart Rate Transmitter
open
(99) Elastic Strap
12
close
(101) Battery Cover
(100) Battery Rubber Ring
(102) Button Battery
(98) Heart Rate Transmitter
Hexagonal
Rubber Area