Pari Trio Instructions For Use Manual page 8

G TAKING A TREATMENT (CONT)
IMPORTANT: Your medication should be at room temperature before use to
ensure that the Trio Electronic Nebulizer operates properly.
2. Pour only the medication prescribed by your physician specifically
for the Trio Electronic Nebulizer into the Medication Reservoir (Figure
15). DO NOT USE MEDICATIONS PRESCRIBED FOR OTHER NEBULIZERS
IN THE TRIO ELECTRONIC NEBULIZER. NOTE: MAXIMUM VOLUME FILL
IS 4 ml. DO NOT OVERFILL THE MEDICATION RESERVOIR.
3. Close the Medication Reservoir by aligning the tabs on the inside of
the Medication Cap with the tab slots in the Medication Reservoir.
Turn the cap clockwise as far as it will go (Figure 16).
15
Figure
16
Figure
TAB
TAB SLOT
QUESTIONS ABOUT TRIO? 1-888-335-6946
5. To begin your treatment, sit in a relaxed, upright position. Press and
hold the On/Off button for one second (Figure 17). You will hear one
"beep" and the status light will illuminate green. The Trio Electronic
Nebulizer is now ON.
6. After a few seconds, aerosol mist will begin to flow into the Aerosol
Chamber.
7. Place the Mouthpiece on top of your bottom lip and tongue, and close
your lips around it (Figure 18). Hold the Trio Electronic Nebulizer level.
If held at an angle over 45 degrees, the Trio Electronic Nebulizer will
sound two beeps (and two green lights) and shut off after approximately
30 seconds. If this occurs, hold the Trio Electronic Nebulizer level and
press the start button to complete the treatment.
8. Take slow, deep breaths in and out through the Mouthpiece. Each
breath should be a little deeper than normal, quiet breathing, but not
to your full capacity. Do Not breathe through your nose. Continue to
inhale and exhale comfortably until the treatment is finished.
9. When all of the medication has been delivered:
a. You will hear the "Treatment Complete Alarm" (2 beeps and
2 green lights).
b. The Trio Electronic Nebulizer will automatically shut off.
10. If for any reason you must stop the treatment before completion,
press and hold the On/Off Button for one second. A 1 beep alarm will
sound with 1 red light. To re-start the treatment, press and hold the
On/Off Button for one second and then resume the treatment.
11. After you have completed your treatment, disassemble the Trio Nebulizer
Handset for cleaning. See Section H for full cleaning instructions.
17
Figure
18
Figure
| 7
STATUS LIGHT