HIKVISION DS-9000-ST Series User Manual page 151

DS-7700NI-SP/9000/9600 Series HDVR/NVR User's Manual

Foreground (Recommended): By using foreground initialization, the RAID will be
initialized totally and the bad sector of the hard disks can be detected and repaired.
The virtual disk can be used only after the initialization is complete.

Fast: The fast initialization usually takes short time and only initializes part of the
RAID, and cannot detect the bad sector.
12. Click the Apply button to save the settings and click OK to return to the Array interface.
13. Click Virtual Disk tab to enter the virtual disk interface. The successfully created virtual
disk will be listed on the interface.
14. Enter the HDD Information interface and the virtual disk will display. For operation guide
of initializing the virtual disk, please refer to Page 116 if you adopt foreground
initialization, the virtual disk will display in the HDD Information interface after the
initialization is complete.
15. After the virtual disk has been initialized, the status will change from Uninitialized to
Normal.
16. Enter the Physical Disk interface to configure the hot spare disk if you have installed the
fourth disk.
17. Select the disk and click
Figure 173 HDD Information Interface
Figure 174 Physical Disk Interface
to enter the Set Hot Spare interface.
151