Spillage Monitoring System - Flavel Pure FPRG**RN2 User Instructions

SPILLAGE MONITORING SYSTEM

This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue pipe. If this system operates the fire will go out. If this occurs,
leave the fire for at least three minutes then follow the lighting procedure as
described in the previous section. In the event of repeated operation a CORGI
registered gas installer must be called to investigate and rectify the cause.
CHANGING THE BATTERIES - REMOTE HANDSET
The battery in the remote handset can be changed by removing the cover on the
rear of the handset and replacing the 1 off R6 9V type battery.
CHANGING THE BATTERIES - ULTRASONIC RECEIVER
The batteries in the ultrasonic receiver can be changed by removing the Pure
fascia. The ultrasonic receiver is located at the bottom right hand corner of the
appliance. Lift the receiver unit from the base panel, slide the top cover off and
replace the 4 off AA batteries.
4