LifeSpan E2i Owner's Manual page 32

Assembling Your Elliptical
H. The Lower Arm Joint Cover (10) comes in two parts. Remove
M4x50L screws from pre-assembled Lower Arm Joint Cover (10A). Place
both halves, shown above, around joint. Re-attach joint cover with
Phillips head screwdriver and 13mm wrench, making sure nut is seeded
in plastic recess. Make sure wires are not pinched and stay in open end in
front of cover.
I. Remove M4x50L screws from pre-assembled Lower Arm Joint
Cover (10B). Place both halves Joint Cover (10B), as shown above, over
exposed wiring. This will overlap the front part of Joint Cover (10A) just
completed in step H. Make sure to keep wiring inside. Use the Phillips
head screwdriver, M4x50L screws and bolts to finish attaching.
J. Repeat steps F – I for other side.
32
M4 x 50L
5mm Allen
Wrench w/
Phillips
PRE-INSTALLED
5mm Allen M4 x 50L
Wrench w/
Phillips
PRE-INSTALLED
H
I