Table of Contents
Advertisement
interrupt occurs. Available settings are:
Power Off
Power On
Last State
PM Wake Up Events
Press <Enter> and the following sub-menu appears.
IRQ [3-7, 9-15], NMI & IRQ 8 Break Suspend
This setting enables/disables the monitoring of the specified IRQ line. If
set to Enabled, the activity of the specified IRQ line will prevent the
system from entering power saving modes or awaken it from power sav-
ing modes. Setting options: Disabled, Enabled.
MSI Reminds You...
IRQ (Interrupt Request) lines are system resources allocated to I/
O devices. When an I/O device needs to gain attention of the oper-
ating system, it signals this by causing an IRQ to occur. After re-
ceiving the signal, when the operating system is ready, the system
will interrupt itself and perform the service required by the I/O
device.
MACPME Power Up Control
This item is used to activate the south bridge LAN controller. When set
to Enabled, any signal from the LAN controller will awaken the system
from power saving modes. Settings are: Enabled and Disabled.
Leaves the computer in the power off state.
Reboots the computer.
Restores the system to the previous status before power
failure or interrupt occurred.
BIOS Setup
3-21
Advertisement
Table of Contents
