Front And Rear Leveling Rollers Removal; Door Gasket Removal; Door Handle Installation; Door And Hinge Removal - Viking VCBF036RSS Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect power to unit before servicing,
Condenser Removal
Condition Requirements:
Condenser Fan Motor Removed
Compressor Removed
NOTE: Condenser is removed by laying unit on its back
and requires at least two people to do this
procedure.
1. Follow reclaiming procedures in Service Procedures
section of this manual.
2. With the help of second person lay unit on back on
raised surface.
3. Remove four torx head screws holding basepan to
cabinet.
4. Lift and remove basepan to access condenser coil.
5. Unbraze condenser coil from connecting tubing.
6. Remove condenser coil by unsnapping it from
retainers in basepan.
7. Reverse procedure for installation.

Front and Rear Leveling Rollers Removal

Condition Requirements:
None
NOTE: The front and rear leveling rollers are removed
the same. The front is shown in this task.
1. Remove toe grille.
2. Raise and block unit to access roller.
3. Screw leveler bolts until they are loose from leveling
roller.
©2007 Viking Preferred Service
WARNING
unless testing requires power.
4. Slide leveling roller out rear of slot.
5. Reverse procedure for installation.

Door Gasket Removal

Condition Requirements:
None
1. Grasp gasket in upper corners and pull gasket out of
dart retainer.
2. When reinstalling door gaskets start at corners
pushing dart edge into retainer and seat gasket flush
to door.

Door Handle Installation

1. Loosen lower door clip on door with a phillips
screwdriver.
2. Locate predrilled hole at base of handle, and fit
hollow end of handle over lower door clip.
3. Fit other end of handle over upper door clip and
slide up as far as possible.
NOTE: If top of handle does not fit over top clip, loosen
4. Insert phillips screwdriver into predrilled hole at base
of handle to tighten screw. Insert plastic button plug
into hole.

Door and Hinge Removal

Condition Requirements:
None
1. Remove screw and top hinge cover.
2. Disconnect connectors from door.
3. Remove screws from top hinge.
NOTE: Do not remove green ground wire from hinge.
4. Remove top hinge along with door.
5. Remove screw and bottom hinge.
6. Reverse procedure for installation.
Disassembly Procedure
lower clip further until fit can be accomplished.
49