Refrigerator Thermistor Removal; Electronically Controlled Damper Removal; Water Filter Removal; Initial Installation - Viking VCBF036RSS Service Manual

Disassembly Procedure
To avoid risk of electrical shock, personal injury, or death, disconnect power to unit before servicing,

Refrigerator Thermistor Removal

Condition Requirements:
Electronic Control Removed
1. Unclip thermistor from control panel housing.
2. Cut wires at thermistor to remove.
3. Reverse procedure for installation.

Electronically Controlled Damper Removal

Condition Requirements:
Door Opened
1. Remove louvered cover from damper control
housing.
2. Remove two screws and damper cover from
damper.
3. Remove foam insert by pulling it off of damper
control.
4. Unclip damper from unit.
5. Disconnect connectors from damper and remove
damper.
6. Reverse procedure for installation.
42
WARNING
unless testing requires power.

Water Filter Removal

To avoid risk of personal injury or property damage;
Use caution when removing, air trapped in system
Condition Requirements:
Door Opened

Initial Installation

1. Remove blue bypass cap and retain for later use.
2. Remove sealing label from end of filter and insert
into filter head.
3. Rotate gently clockwise until filter stops. Snap filter
cover closed.
4. Flush air from system by running water continuously
for two minutes through dispenser until water runs
steady.

Replacing Water Filter

1. Turn filter counterclockwise until it releases from
filter head.
2. Drain water from filter into sink, and dispose in
normal household trash.
3. Remove sealing label from end of filter and insert
into filter head.
4. Rotate gently clockwise until filter stops. Snap filter
cover closed.
5. Flush air from system by running water continuously
for two minutes through dispenser until water runs
steady.
CAUTION
may cause water and cartridge to eject.
©2007 Viking Preferred Service