Table of Contents
Advertisement
General Information
• Most of the unit's weight is at the top.
TIP OVER HAZARD
Extra care is needed when moving the unit
Appliance is top heavy and tips easily when
to prevent tipping.
not completely installed. Keep doors closed
• Do Not remove protective film until unit is
until appliance is completely installed and
in operating position.
secured per installation instructions. Use two
or more people to move and install
• All four leveling legs must contact the floor
appliance. Failure to do so can result in
to support and stabilize the full weight.
death or serious injury.
• Do not drop unit.
Unpacking unit
• Remove exterior shipping materials prior
1. Remove top and bottom strap.
to moving unit into home.
2. Remove top cap.
• Use two or more people to move and
install unit. Failure to follow this instruction
3. Cut carton rear approximately 1/4"
can result in back or other injury.
• To avoid personal injury, wear gloves when
4. Remove carton and exterior packaging.
performing any installation procedure and
wear eye protection when cutting metal
straps.
Moving Unit
Remove shipping brackets from skid by removing
4 bolts (2 on each side) with a 1/2" deep-well
socket wench and a pair of pliers.
Note: Tilting unit is not required to remove
shipping brackets.
8
(0.6 cm) to 1" (2.5 cm) from right corner
with a utility knife extended 1/4" (0.6 cm).
Save cardboard shipping material to
protect floor surface when installing unit.
Remove anti-tip board, kickplate and door
trim pieces (DF models) from rear of unit.
Slip appliance dolly between unit and skid. Only
use dolly from the rear of the unit to remove unit
from skid. After the unit is removed from the
skid, a dolly can be used from either side or the
back BUT NOT THE FRONT.
Note: Use excess packaging to protect
decorative trim; also, verify that leveling legs are
up (0" adjustment).
Grille Removal
1
Place unit in front of cutout.
2b
(Designer) Pull the center grille louver up
at an angle and pull out.
4
Remove grille assembly.
9
2a
(Professional) Lift center grille louver up
and pull out.
3
Using an 8" magnetic nut driver, remove
the two 1/4" screws.
Advertisement
Table of Contents
