Leveling Unit; Kickplate Installation - Viking FBI7360 Installation Manual

Leveling Unit

Once the unit is in position, height adjustment can be made
from the front. Remove panel just below the water fi lter.
Using a 5/16" hex drive, turn clockwise to raise the unit or
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the leveling legs
by hand. When the unit is properly leveled, door/drawer
adjustments are less likely to be necessary.
IMPORTANT NOTE:
Level the unit to the fl oor, not
surrounding cabinetry. This could aff ect the operation of the
unit, such as door closing.
Left Front
Adjustment

Kickplate Installation

After the unit has been adjusted to the proper height, place the kickplate on the lower front with the adjustment
screws in the slots. Let the kickplate drop until it hits the fl oor. Tighten the screws.
Adjustment slot
Adjustment screws
Front Panel
Left Rear
Adjustment
Front of unit
kickplate
17
B
A
Right Rear
Adjustment
Right Front
Adjustment