Mounting The Switch On A Workbench; Connection Of Power Cord And Ground Wire (S2016-Ei/S2403H-Ei); Connecting Ac Power Cord (S2016-Ei-Ac/S2403-Ei-Ac) - Huawei Quidway S2000-EI Series Installation Manual

Installation Manual
Quidway S2000-EI Series Ethernet Switches
Figure 3-4 Mounting the switch (into a 19-inch rack)
Note:
The mounting brackets are used for fixing rather than weight bearing. In a 19-inch standard rack, the
weight of the switch is supported by the shelf beneath it.

3.3.2 Mounting the Switch on a Workbench

When a 19-inch standard rack is not available, you can simply place the switch on a
clean workbench but should make sure:
The workbench is stable and well grounded.
A clearance of about 10 centimeters is reserved on each side of the switch for
heat dissipation.
No heavy object is placed on the top of the switch.
3.4 Connection of Power Cord and Ground Wire
(S2016-EI/S2403H-EI)

3.4.1 Connecting AC Power Cord (S2016-EI-AC/S2403-EI-AC)

I. AC power socket (recommended)
You are recommended to use a monophase three-wire power socket with a neutral
point or a multi-functional power socket for computers. The neutral point of the power
in a building must be well grounded. Normally, the neutral point of the power supply
system in a building was buried in the ground during the construction and wiring. Still,
you should make sure of that.
3-4
Chapter 3 Installation