Huawei Quidway S2000-EI Series Installation Manual page 43

Installation Manual
Quidway S2000-EI Series Ethernet Switches
Parameter requirements: Set baud rate to 9600, data bit to 8, parity to none, stop bit
to 1 and flow control to none. Select VT100 as terminal emulation. The specific
means are as follows:
Click [Start/Program/Accessories/Communications/HyperTerminal] to enter
1)
the HyperTerminal window in which click icon
connection and the system will pop up the connection description interface
as shown in the following figure.
Figure 4-2 Connection description interface of HyperTerminal
Key in the name of the new connection in the connection description
2)
interface and click <OK>, the system will pop up the following interface
picture. Select the serial port to be used from [Connect using].
Chapter 4 Powering on Switch for the First Time
4-2
to establish a new