Table of Contents
Advertisement
DIE IDENTIFICATION FOR USE WITH MATCHED CONNECTOR
1. Always verify correct die set by die part number.
2. Color coding dot for verification may be found near die crimp pocket.
PANDUIT
PART
NUMBER
CD-920 SERIES DIES
PANDUIT
PART
NUMBER
DIE COLOR DOT
CD-940 SERIES DIES
DIE INSTALLATION
DO NOT operate tool without dies installed.
CAUTION:
1. Select the appropriate dies to match the connector to be crimped.
2. Align one of the die halves in the die cavity contour in the tool head or ram. While depressing the die release buttons,
slide the die half so it is seated in the die cavity. Release the die release buttons and check to ensure the die is locked
into place. Repeat procedure with second die half.
CT-930CH, CT-930LPCH and CT-940CH OPERATING INSTRUCTIONS
PANDUIT
RED P21
CD920-8
DIE COLOR DOT
PANDUIT
CD-940-750
P106
DIE COLOR CODE AND DIE
INDEX NUMBER FOR COPPER
AND ALUMINUM COMPRESSION
DIES.
DIE COLOR CODE AND
DIE INDEX NUMBER FOR
COPPER AND ALUMINUM
COMPRESSION DIES.
Page: 4 of 6
P 1 0 6
Advertisement
Table of Contents
