Installation Of Positioning Device (Pd-600-A) - Panduit CT-600-A Operating Instructions Manual

© Panduit Corp. 2013
TOOL CLAMP
BLOCKS
HEXAGONAL
SOCKET HEAD
SCREW (1)
M10 x 16mm
BASE PLATE
CLAMPING SCREW

INSTALLATION OF POSITIONING DEVICE (PD-600-A)

1. Clamp Positioning Device on edge of table.
2. Remove both screws holding the Tool Clamp Blocks
3. Install CT-600-A between Tool Clamp Blocks, away from CT-600-A's Actuation Lever.
4. Tighten both Tool Clamp Block Screws.
5. Use Swivel Clamp Arm to loosen Positioning Device and position CT-600-A for operation.
OPERATING INSTRUCTIONS
POSITIONING DEVICE (PD-600-A)
(Sold Separately)
Page: 5 of 12
HEXAGONAL SOCKET HEAD
SCREW (2) M12 x 80mm
POSITIONING CLAMP
SWIVEL CLAMP ARM
CT-600-A