Test Operation - Daewoo DWD-M301WP Instruction Manual

n manual 4-1. Drill a hole through tile
- Notch below the marking hole.
pot. - Drill a hole perpendicular to the wall surface.
l product ※ Do not drill a hole on the edge of wall tile.
※ Do not drill a hole right below the faucet.
cord 9. Organize hoses
by the - Place hoses in the hole.
ng wire.
s. ※ Prevent the hoses from becoming jammed between the
wall and washer.
e place.
13-2 Install the inlet hose - Kitchen sink, shower
 Lock the water supply valve
 Install the branching adapter (Install adapters respectively on cold and hot water taps)
 Branch off the inlet hose
D-M301WP_INTENSIVE_호주향.indd 27
4-2. Drill a hole into the retaining wall
- Set the hammer drill perpendicular to the wall
surface and then drill a hole into the retaining
wall.
※ Follow the instructions on the diameter and depth
specifications for the hole.
※ Remove dirt from inside the hole.
10. Inject chemical anchor and insert cushion pads
- Inject chemical anchor into the fixed set anchors.
- Insert cushion pads on the fixed anchors.
- Attach pads to the wall.
 Disassemble the water supply valve
Cold
Hot water water
| 26
5. Insert set anchors (4 holes)
- Insert set anchors into holes.
- Set anchors are included in the product
package.
※ Insert set anchors to the end of holes.
※ The set anchor bolt must be 75mm long or longer above
the wall.
11. Install the washing machine
- Install the washer on the surface of wall so as
not to create a large gap.

14. Test Operation

- Run a test operation to identify any
malfunctions or leaks.
For
hot
water For
cold
water
|
2014-02-03 오후 4:18:36