Installation Guide - Daewoo DWD-M301WP Instruction Manual

Installation Guide

The washer is recommended to be installed by a professional service engineer.
Before installation
After installation
1. Determine the location for installation
- Determine the installation site after discussing
the site structure with the customer.
※ Breast-high location is convenient for installation.
※ Installation and use are convenient with access to water
supply, drainage, and electric outlets.
6. Fix set anchors
- Fix set anchors with an anchor hammer.
※ Redo the fixation if the anchor cap protrudes above the
wall surface after fixation.
12. Fix the washing machine
- Connect the fixing nut (1EA) after inserting the
flat washer (1EA) and spring washer (1EA) and
then connecting a regular nut (1EA).
- Fasten the nut with Ø14 spanner.
※ Excessive fastening of nut may destroy the product or
wall tile.
※ Fixing nut must be fastened tight.
D-M301WP_INTENSIVE_호주향.indd 26
Install the washer without plugging in the power cord.
Perform a test run to identify any water leaks or abnormal noise.
2. Inspect wall
- Knock on the wall with your hand to check the
existence of retaining wall inside.
※ Install the washer on an even wall.
7. Connect inlet and drain hoses
- Insert the inlet hose until the elbow makes a snapping sound.
- Connect the clamp inside the synchronous motor after fixing the
drain house to the synchronous motor.
※ Connect hoses properly to prevent leaks.
※ Insert the inlet/drain hoses into the back holes after
connection.
 Lock the water supply valve
 Install the branching adapter
※ Wrap the connection of branching adapter and water supply valve with Teflon tape.
※ Examine whether a water leak occurs after instillation.
| 25 |
3. Attach installation instruction manual
- Use a level meter for attachment.
- Attach a guide and mark the hole spot.
※ Attach the manual in consideration of actual product
size.
8. Connect the power cord
- Connect the power cord as requested by the
customer (upward, downward).
- Attach a connector and fix the grounding wire.
※ Fix the upward power cord tight with clamp cords.
※ Fix the grounding wire with grounding screws.
※ Do not ground multiple grounding wires in a single place.
13-1. Install the inlet hose - Regular Tap
 Disassemble the water supply valve
 Branch off the inlet hose
4-1.
- Notch bel
- Drill a hol
※ Do not dril
※ Do not dril
- Place hos
※ Prevent the
wall and w
 Lock the
 Install th
 Branch
2014-02-03 오후 4:18:36