Advertisement
Step 4-Scale
Push Scale button and go into scale setting menu. Use
UP or DOWN to go to Horizontal size, Vertical size,
Horizontal position, Vertical position setting page, and
push SEL to decide to set, and use UP or DOWN to
change the size or position value. Push SEL to send and
exit from the setting.
Keep pushing UP or DOWN button, the value
NOTE
of the size or position will change faster and
Faster during setting values.
Rate of change will be from 1 to 10 and to 100.
Step 5-Save
VSP 5162 supports 10 user saving modes. Push SAVE
button and SVAE1~ SAVE10 buttons will light on, push
any one of them to save the setting. After that user can
push each of them to call the setting.
SAVE1 setting is default user setting after
NOTE
VSP 5162 power on.
All the user settings will gone after factory reset.
Step 6- Save mode loading
VSP 5162 supports 10 user saving modes, make sure all
the saved parameters right, push LOAD button, and
SVAE1~ SAVE10 buttons will light on, push anyone of
them to confirm loading the save mode by pushing UP
and DOWN, push SEL to confirm.
All the user settings will gone after factory reset.
Factory Reset: When there is wrong operation
NOTE
during parameter adjustment, users can recall
the device and readjust the parameter. Following the
steps: Press MENU button ,choose the submenu Reset
and press SEL to initiate factory reset.
>VSP 5162
Dev Info
Remote Control- Software Control
NOTE
the WINDOWS operating system, please
refer to the user manual and please select
the correct language version during
installing process.
Step 1-Set up communication
Choose useful RS 232 control port of computer, set
baudrate at 115200.
Communication
communication button
Set the computer in a network segment with different IP
addresses, then communicate, for example: 192. 168.0.99
Step 2-Set up working mode
*RESET
About how to install this software in
Default
IP:192.168.0.100
In "Group Config" there is the option for
operation to the signal group, select the
appropriate signal mix to configure.
In the Group Config menu
users can also set the
brightness, contrast, color
temperature and other
regulation.
NOTE
The current adjustment only works
for current selected input source, the
adjustment can be saved to the device.
Step 3- Set up switch mode
Choose Switch Effect such as fade-in-fade-out
from the list of Effect Mode.
Switching time
and speed are
also set here.
After presetting data, users can see the effect
from Program output by pressing TAKE
button. Users can achieve the switch effect
with lateral push-and-pull rod. CUT is the fast
switch with no transition effect.
Step 4-Preview Operation
Through button 123456 in Preview window of
the PC software, 12 button is to monitor
signal from program input 12, 3 is to monitor
DVI3 input, and 4 for VGA3 input, 5 for DVI4
INPUT, 6 for VGA4 input.
Step 5-Program seamless switch effect
Through button 123456 in program window of
PC software, or CUT, TAKE button to do
seamless switch between signals.
VGA of DVI+VGA
output connecter
is the preview
output of PC
software, could be
connected with
VGA monitor.
DVI of DVI+VGA
output connecter is
the program output
of PC software,
could be connected
with VGA monitor
VSP 5162 Quick Start
Rev 1.0
Page 3 of 4
Advertisement
