Pro-Form 980 CS User Manual page 11

Hide thumbs Also See for 980 CS:

12. Press the Left Accessory Tray (99) and the

Right Accessory Tray (97) into the console as-

sembly.

Console

Assembl'

13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex

keys is used to adjust the walking belt (see pages 27 and 28).

If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re-

ceiver included with the chest pulse sensor.

14. Make sure that the power cord is unplugged.

Remove the indicated #8 x 3/4" Screw (1) and

the Access Door (87) from the Console Base

(91).

15. Connect the wire on the receiver to the indicated

wire extending from the Console Base (91).

Hold the receiver so that the antenna is ori-

ented as shown and is facing the Console

Base. Attach the receiver to the plastic posts on

the Access Door (87) with the two included

small screws.

16. Make sure that no wires are pinched.

Reattach the Access Door (87) with the #8 x

3/4" Screw (1). Discard the other wires included

with the receiver.

Small

Screws