Table of Contents
Advertisement
installation
|
46
OPTIONAL ENAMEL PANEL INSTALLATION
• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and finger marks MUST be cleaned off with a soft cloth.
gerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
RIGHT
1) Remove the heat deflector by removing the 2 screws securing the
heat deflector to the top of the firebox (see Diagram 2).
Heat deflector
2) Install the back panel first - use care when clearing the burner assembly
and rear log tray, so panel is not scratched.
NOTE: Orient the panel so the fold in the metal faces towards inside the firebox.
46 |
Bellavista® B36XTE-10 Gas Fireplace
918-807a
BLACK ENAMEL PANEL INSTALLATION
TOP
BACK
LEFT
Diagram 1
Diagram 2
Diagram 3
Black Enamel Panels
Use an ammonia based cleaner (ie. glass cleaner) to remove any fin-
3) Install the top panel next - slide the panel in over top of the back panel
(see inset A).
Diagram 4
4) Remove 1 screw (see inset A), position right side panel in firebox -
position panel clip in place and secure with 1 screw (see inset B).
Tighten the screw.
Diagram 5
5) Repeat step 4 for left side panel.
6) Reverse step 1.
1
B36X / XT
Fold
A
B
Diagram 6
Final Installation
A
05/15/12
Hide quick links:
Advertisement
Table of Contents
