Miele KM 89-2 Operating Instructions Manual page 18

Installation instructions
Installation instructions
2 zone Combiset
1 Combiset
2 Combisets
3 Combisets
4 Combisets
5 Combisets
4 zone Combiset
1 Combiset
2 Combisets
3 Combisets
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
Extractor (e.g. DA 8-2)
For building in between two appliances:
- Dimension B increases by 3 9/16".
For building in at the end of a combination:
- Dimension B increases by 3 7/8".
* Width includes provision for V 98 spacer bar
Place the provided seal
edge of the Deep Fryer.
18
Depth Width *
in (= Dimen-
inch sion B)
in inch
19-5/16" 10-7/16"
19-5/16" 22"
19-5/16" 33-1/2"
19-5/16" 45-1/32"
19-5/16" 56-9/16"
19-5/16" 22"
19-5/16" 45"
19-5/16" 68"
19-5/16" 33-1/2"
19-5/16" 45"
19-5/16" 56-9/16"
19-5/16" 56-1/2"
19-5/16" 68-1/16"
.
f
under the
loosen
b
Appliance
c
Tensioning screw
d
Clamp
e
Countertop
f
Seal
Turn the tensioning screws
counter clockwise until a resistance
is felt, then turn the clamps
left.
Place the appliance into position,
turn the clamps and tighten the ten-
sioning screw until the clamps press
into the countertop
Connect the appliance to the electri-
cal supply.
When installing several Combiset units,
a stainless steel spacer bar must be
placed between the units. It is supplied
with its own installation instructions.
tighten
c
d
to the
e
, as shown.