Table of Contents
Advertisement
3)
Remove the two screws from the control PWB unit.
4)
Pull out the control PWB unit.
D. Attach the FAX memory.
1)
Install the FAX memory to the socket on the controller PWB as
shown in the figure below so that the memory notch is on the
right side.
E. Attach the interface cable.
1)
Connect the interface cable to the control PWB unit.
[Note] Check that the connector is not obliquely inserted.
2)
Push the interface cable into the recessed portion of the sheet
metal on the control PWB unit.
3)
Attach the snap band to the sheet metal of the control PWB
unit.
F. Attach the control PWB and the right rear
cabinet.
1)
Push the control PWB unit into the main unit and secure it with
the two screws.
2)
Cut out the cut-out portion of the right rear cabinet.
3)
Fit the interface cable into the opening that has been cut.
4)
Attach the right rear cabinet cover to the main unit.
At this time, check that the four hooks are properly fitted to the
main unit.
5)
Secure the right rear cabinet with the screw.
6)
Attach the ozone filter cover to the main unit.
MX-2300/2700 N/G MX-FXX1 19 – 2
Hide quick links:
Advertisement
Table of Contents
