Sharp MX-2300 G Installation Manual page 12

5) After entering the data, close the front cabinet.
6) Select K, C, M, Y and then press the [EXECUTE] button. The
system then performs the simulation, samples the toner den-
sity control sensor value, and sets (stores in memory) the
average sensor detection level as the control level for the ref-
erence toner density.
SIMULATION NO.25-02
TEST
AUTOMATIC DEVELOPER ADJUSTMENT
AT DEVE VO_L_K
: 128
AT DEVE ADJ_L_K
128
:
AT DEVE ADJ_L_C AT DEVE VO_L_C
128
:
AT DEVE ADJ_L_M AT DEVE VO_L_M
: 128
AT DEVE ADJ_L_Y
AT DEVE VO_L_Y
K
C M
Y
Note: Be sure to select all of the four colors: K, C, M, Y.
7) Exit from Simulation mode by pressing the [CA] key on the
main unit.
G. Installation of individual color toner cartridges
* The life of each toner cartridge is as follows:
Black toner cartridge: equivalent to approximately 18K (A4/LT
5%)
Color toner cartridge: equivalent to approximately 15.0K (A4/LT
5%)
1) Shake the toner cartridge (package part No. 1) horizontally
several times.
0
CLOSE
: 128
128
:
128
:
: 128
EXECUTE
1/2
MX-2300G/N, MX-2700G/N 1 – 9
2) Remove the heat seal.
3) Open the front cover, and insert each toner cartridge.
* Be sure to install the color cartridges to their proper posi-
tions. Avoid installation to a different color position.
* Do not forcibly insert the toner cartridge.
Keep holding the cartridge and completely insert it.
* When the machine is transported with the developing unit
removed, be sure to remove the toner cartridge. (If not, tone
may be clogged.)
[Color toner cartridge positions]
Y M
4) Insert the cartridge securely until it locks.
C BK