Sharp MX-2300 G Installation Manual page 43

3) Disengage two pawls, and remove the paper exit tray cover.
4) Remove four screws, and remove the paper exit tray.
* When removing the paper exit tray, there is no need to
remove the screws in the section (A).
5) Remove the paper exit full detection actuator.
6) Engage the projection on the main unit frame with the hole in
the finisher fixing plate (package part No. 1).
7) Fix the right cover plate with the fixing screw (package part No.
8).
* Fix the side plate of the paper exit shifter with the fixing
guide.
8)
9)
A
10) Check to insure that the slide roller is in the rail groove, and
11) Fix the rear slide rail with the fixing screw (package part No. 8).
MX-2300/2700 N/G MX-FNX1 6 – 3
Install the front slide rail (A) (package part No. 2) with the three
fixing screws (package part No. 8), and install the left front
cover (B) (package part No. 6) with one fixing screw (package
part No. 8).
B
Fix the dummy punch unit (package part No. 3) with the fixing
screw (package part No. 8).
insert the inner finisher.
A